Recipe
I began by creating each of the faces. The numbers must go from least to greatest counterclockwise or the numbers will count down when it is put up. I then made the clock holder so I could hang it on a wall. The faces were made in Adobe Illustrator whereas the holder was made in Autodesk Inventor. I engraved the numbers and cut out the faces in the laser. Every multiple of 5 on the minute face was cut out from vinyl. I 3-D printed the holder in Makerbot.
What I Learned
I Learned in this final project to not try and fit your clock mechanism into a 3-D printed holder that you haven't cleaned up yet. You just break your mechanism. And you can't get a new one.